How to change the IP address range used for auto configuration

The range used for auto configuration is set the in 'Advanced' Network menu.

As default the IP range used is 192.168.230.XXX

 

To change the auto configuration range, log in to the NVR and navigate to Network --> Advanced --> TCP/IP

You will need to change the IP address and subnet in the '1st IP address' section.

 

advanced-network.jpg

 

If you would like the cameras to be auto configured with specific IP addresses, change the IP address in the '1st IP address' section to an IP address 1 digit below the first cameras starting IP address.

E.G

If i wanted my cameras to have the IP address 192.168.0.201 - 204 i would set the NVR Advanced IP address to 192.168.0.200.

Auto-assign-IP-change.jpg


Cam1-Auto-IP.jpg

Please note ALL IP address entered in to the NVR MUST be available on the network and not used by another device, otherwise an IP conflict will occur.

When changing the IP address in the 1st IP address' section, it is recommended to use the IP Test feature to confirm that the IP address you would like to use is available.

Simply change the IP address and press the 'IP Test' button. This will test the IP address availability, if available click 'Apply' at the bottom of the page.


IP-available.jpg

 

 

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

0 Comments

Article is closed for comments.