New Router / Router Change Guide

Disclaimer: This guide is intended to help get your CCTV system back online after a router change. It is a basic fix and not a full CCTV system configuration. 

If you need help with a complete configuration or are unsure about any of the steps, please contact your installer or a qualified network engineer.​‌

 

This guide is intended for users who have recently had their broadband router replaced and can no longer access their CCTV system. In most cases, the issue occurs because the new router uses a different IP address range (Subnet) than the previous router.

Many CCTV installations use static IP addresses for the NVR and cameras. When the router changes, devices configured with the old network settings can no longer communicate correctly with equipment using the new network settings.

Although these steps are relatively straightforward, they are best carried out by someone with basic networking knowledge.
 

Restoring CCTV Connectivity After a Router Change

Step 1: Access the NVR

Connect a TV or monitor directly to the NVR and log in to the system menu.



Step 2: Check the Current Network Settings

Navigate to:

Main Menu → Network

Make a note of the current IP address, Subnet mask, Default Gateway and Primary DNS before making any changes.



Step 3: Configure the NVR for the New Router

  1. In the Network menu, change IP Mode to DHCP.
  2. Apply the settings.

The NVR may reboot and will request new network settings from the router automatically.

Once the NVR has restarted, it should receive a valid IP address from the new router and regain internet access.

Important: At this stage, the NVR will lose communication with the cameras because they are still using IP addresses from the previous network.



Step 4: Restore Communication with the Cameras

To allow the NVR to communicate with both the new router and the existing camera network:

  1. Navigate to: Network → Advanced
  2. Ensure TCP/IP 1 is enabled.
  3. Under 1st IP Address, enter the NVR's original IP address (the one noted in Step 2).
  4. Confirm the Subnet Mask matches the original camera network configuration.
  5. Click Apply.

The NVR should now be able to communicate with the cameras again.



How This Works

The NVR is now connected to two networks simultaneously:

  • The new router network, allowing internet access and remote connectivity.
  • The original camera network, allowing communication with the cameras.

This is normal operation and will not cause any issues.



Step 5: Check Remote Access

Once live camera images are visible on the NVR, test remote viewing using the mobile app.

If the app can no longer connect to the NVR, the device may need to be re-added.

The recommended method is to use the NVR's P2P (Peer-to-Peer) service, which does not require port forwarding or advanced router configuration.


Adding an NVR to LILINPro Using P2P (3 Series NVR's and above)


 

Important: Older legacy L Series NVRs use the LILINViewer app for remote access, LILINPro is not supported. 

If you are using an L Series NVR, your recorder may not support P2P (Peer-to-Peer) connectivity and may never have been configured using this method.

To check whether your L Series NVR supports P2P, enter the NVR menu and look at the bottom left of the main menu screen:

  • If a QR code is displayed along with a long device or registration code, your NVR supports P2P.
  • If there is no QR code, or the QR code has "UID" displayed underneath, your NVR does not support P2P.

If this applies to your system, you will not be able to follow the P2P setup guide above. Instead, you will need to configure port forwarding on your new router to enable remote access.

Port Forwarding Guides (For older legacy products.)

 


 

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

0 Comments

Article is closed for comments.